U.S. NAVY Chevy Step Side Task Force PU

Modeling Subjects Armor
21

hey redleg12, yup it worked.

disastermaster, if it didn’t, that would’ve been the alternative material, thanks for tip

A sharpened pencil tip was used to shape and hold each radius because of the variable corners and the porous wood material broke free easily from the CA where it touched

The lower piece at the bottom of the cab cracked free during this over handing but that’s cool, it’s fixable

thanks for looking . . .

22

Hello!

A very nice truck and an original idea, too! Too bad they don’t make’em in 1:35, isn’t it? Good luck with your project, have a nice day

Paweł

23

Hi Pawel, yeah true that.

Thanks for looking in my build thread

24

While I’m trying to figure out the front windshield and it’s bogus fitting glass part. …

I finished the seat back detail to match the seat bottom seam part.
Sprue was stretched to the same diameter and then glued, trimmed and sanded in place

match is made

25

Nice w.i.p. you have going here [Y]

26

Thanks lookin in Carl [H]

27

…[Y]