Thank you all again for all the suggestions and help… here is the next set of work and pics.
The tow cables had to go… I found a potential new way (for me) of scratchbuilding them using ship rigging thread, but may skip tow cables for this build.
I added a pin wash, 10:1 enamel (dark brown), have to be careful to use MM thinner instead of odorless/turpenoid in order not to disturb the underlying oil/turpenoid weathering layer. Then added an additional sludge wash (dark brown, acrylic, in water + 1 small drop dish detergent) in order to make is a tad "dirtier. I like the sludge wash in acrylic/water, since I can then use a Q-tip to dab any excess sludge and “shape” the weathering. Finally, I fixed a “rookie” mistake, in that I did not weather the under-front/back of the hull (not that anyone should be picking up the model to look underneath!), but it was obvious to me.
I added more oil weathering to the front fenders, trying to get a “used” look to them, maybe I should dry brush a bit the fender edges?


Overview of the sludge wash:


Brushed some Tamiya Smoke acrylic on the grills, will follow up (post sealant) with chalks

Tried to give the mufflers a tad of “texture”…did it work? And where do the exhaust smudges (if any) point? Cant find any good ref pics 

Also, used a bit of a kitchen scrub pad, dabbed in burnt sienna oil paint, to “stamp” a few scratches:

The vinyl threads were “up in the air” on the top part, not making contact with the top of the wheels. I dabbed some CA and glued the top of the wheels to the track. You can also see a bit of the wheel weathering: (amd YES you also see the staple holding the tracks together…next time, i will move the tread joint to the bottom, and cover up with some mud!)


Finally, I painted the inside of the light lens silver, filled with clear glue, topped off with Future. I figure that may look better than the plastic lens painted silver!

What is next? I will “seal” the weathering with couple fine mist layers of Future, then (after letting the Future cure couple days, its very humid here!) give it a layer of testors dullcote to get rid of the “shiny”. Then some modest weathering with pigments/chalks. oh, and glue the antenna back and as the LAST step so i dont keep breaking it off 
As usual, any and all comments and suggestions regarding consruction, techniques and accuracy MORE than welcome!