I am new to the aftermarket accesories for cars, and I dunno how to add the wheels to the suspension, the holes done fit over the stock place where the stock rims would go.
Hey Shiako, if we are talking about plastic on plastic there is an easy fix that I have done a few times.
If the new wheel/rim assembly hole is too small to fit the kit:
- Drill the hole bigger in the rim backing plate.
- File and sand the sindle smaller so the rim will fit.
- I did both, taking a little material from each item and they fit without problems.
If the new wheel/rim assembly hole is too big to fit the kit:
- Take a scrap piece of sprue (sand/file to fit) and glue inside new rim backing plate.
- Drill hole in center of newly inserted piece of sprue to fit spindle of kit.
Hope that was what you were looking for?