Need an assist

Hey gang,

Was recently applying decals from STModeler to my 1/650 TOS Enterprise. Managed to get them all on correctly except for one, that’s right the big NCC-1701 on the forward saucer section which disintegrated. My question is, does anyone know the font size and font type for this decal. I may have kinko’s reproduce the decal or create a stencil. Better yet does anyone have a template that they can email me. I would really appreciate it. Thanks ahead of time. [:D]

Why not contact the manufacturer for a replacement. I know JT Graphics will replace decals when there are problems. It couldn’t hurt to ask.

Normally I would, but am at the point where I dont want to wait the week and a half for it to show up in the mail

I think they used Microgramma Extended

MASK AND AIR BRUSH!if you need it that quick it’s the only way.

…and create a stencil, dont forget that important part. [;)] Thanks cmtaylor, I downloaded a set of those fonts and they look pretty close. Now a little magic in photoshop and its off to kinko’s I go.