Working with a propellor on a Ju-87 Stuka

Modeling Subjects Aircraft
1

Hello

I am working with the propellor on a Ju-87 Stuka. Is there a way to mount the propellor on the pin without using glue. I had to glue the little pin to the engine block because it would always fall out and would be very difficult to put back in the proper location. Now I have the engine put together with the pin sticking through it to allow the propellor to attach.

Thanks

Scott

2

Scott - I am not sure how to go about fixing your problem. Perhaps this will help you in a future build - I always make a block to hold the pin out of scrap styrene. I prefer to add the prop last and still want it to turn.

ShaftThe little block of styrene was cemented at the 4 conecting points only