I have just received, as a birthday gift, a couple of AMT re-issued vinyl Star Trek figures. I have never worked with vinyl before and am rather clueless as to how to proceed. I would appreciate any tips and advice from anyone who has experience with them. I am very experienced with styrene and resin work, but vinyl, at this point, is a new horizon for me. Thanks- Chuck
While I haven’t yet worked with vinyl kits I do have a few in my stash.
I would suggest picking up David Fishers DVD(s) since they not only cover resin garage kit’s but also vinyl.
Items mentioned.
1, Heat with blow dryer to soften for cutting, use a fresh exacto and be very careful and take your time.
-
Glue together using CA glue (super glue)
-
Use lacquer based primer misted on.
-
Unless fully sealed don’t use enamel paint as it will never cure
-
kit’s can be filled with 2 part expanding foam, plaster or paper to help keep their shape.
-
Wire framing and 2 part epoxy putty (Magic Sculpt, Aves) can be used to modify the figure.
Thank you, sir, that is helpful information-
Chuck