Tom's Modelworks and Copper State Spandau guns

Modeling Subjects Aircraft
1

I am currently putting together a 1/28 Revell Fokker Dr.1 and am trying to give it more detail. I have both the Copper State and Tom’s Modelworks Spandau guns but the Copper State instructions are not readable and the Tom’s Modelworks guns didn’t even come with any.

Is there any legible instructions out there for either kit, especially Tom’s ?

Thanks in advance for any help.

2

I have Toms PE Spandau guns in 1/48 with instructions…not sure if they’re the same animal just scaled down from the 1/28 set. I’m guessing they might be as much of the detail is extremely fine. I could scan you a copy (when my wife gets home, because it’s her scanner and I haven’t a clue how to use it).

3

That would be great if you could. I was doing more searches on this forum and found a link to the PDF instructions for the Eduard 1/48 spandau photo etched part. It’s different than Tom’s 1/28 guns but at least some ofthe parts are recognizable. Any instructions you may have would be great to see though since they are Tom’s.

Thanks a bunch!!

4

Greetings gents;

It should help greatly both sets are from the same negative. You can contact Tom directly at his Tom’s Modelworks website.

5

Thanks, Stephen. I thought that might be the case. Wally…check your messages.

6

Got the PDF. It will help a lot and gives me an idea of what I need to do.

Thanks a bunch for the quick response !!