StuG III C/D, Dragon DR 6009

Modeling Subjects Armor
1

Hi all,
I have only just picked up modelling again after a long brake, and when I unpack what was stoved away many years ago its pretty much a mess.
Sadly I have found that I have lost the drawing to my Dragon 1/35StuG III, DR 6009.
Most of the kit is pretty straightforward but I do have problems when it comes to the etched parts and the commanders hatch and aming tools.

Anyone out there who can help me with a copy or just a few words of guidens?

And from your experience, does the kit not luck “empty” when you install a commander in an open hatch?

Looking forward to your advise :slight_smile:

2

I think I have a set of those in my basement. I will look for you this evening and scan them in.

Ted

3

Would be super! [:D]
jt@dof.se does not have the hotmail 2Mb restriction.

Thank You.

Johan

4

Welcome to the forums
good luck in your search,
is there any chance you could post some photos when its done[:)]

5

Thank You Captain Caveman!
Sure I will, I am not familiar to the techniques used to publish a photo in here but I recon I can learn that in here aswell…
Internet was not arround when I left*, but hey, what a boost in knowledge sharing to a community like ours.
Have not been able to really leave the forums for more then like a few minutes since I joined yesterday, and have allready had very valuable help!

*I’m not a dinosaure, its only 2 kids ago…