Radio set for a Marder III Ausf M?

Modeling Subjects Armor
1

And if you happen to have a wiring diagram…[whstl]

2

I hope wbill will come to your rescue… with a wiring diagram! [:D]

3

All I GOT is this.

4

I saw one just this morning online and for the life of me I can’t remember where it was. I was going to save it for myself and my PC went down. It showed the whole set up with the headset and several different wires on the front.

5

This is the wiring diagram for a full-on Marder II radio arrangement, however a standard Marder III M wouldn’t have had both the sender and receiver, just the receiver. Only the command versions had both.

An accurate representation of the wiring is how I rigged up mine when I built it back in 2007, might help you out as well.

6

Thanks boys…that works. I really need to learn how to search better. But I was in a total fog last night. If I had gone out I might not have found my house.[whstl]

7

This helps me out as well as I am building a Marder III.

Bill what is the box directly above the shells on the left? Is the little “nub” on the top a base for an antenna? or where would the antenna go?

Thanks for the image and diagram!!

8

The antenna on the Marder III-M mounted on the exterior of the fighting compartment armor plate. What you are seeing is the small junction box that the antenna cable connected into. HTH!

9

Good stuff!

I’ve got the Dragon Marder III Ausf M Command Vehicle in my stash and I know that getting the wiring rigged up correctly is going to be play a big part in this build so I’ll be following this thread very closely.

Thread bookmarked!

ATVB

Ben [H]