I bought a 1/32 cockpit detail set from WINGZ Aero Products…the set is very nice but I have hit a bit if a snag…
While trimming off the flash that was attached to the lower part of the seat…the part the pilot would sit on, I ended up damaging and craking the fragile resin, all atempts I have mad thus far in trying to reapair it have failed, and I think mad the seat look worse…
Would anyone happen to know how to contact these guys to see if I can get another seat? I have tried the net, but my google-fu isnt so good…
other than that, sugestions on what I wmight be able to do
Ashton
I can’t say that I have ever heard of that manufactor. What type of plane is it. If it is a modern jet you can often buy the ejection seat by its self. I think Eduard od Aires might make the Martin Baker ejection seat in resin. If it for a old WWII kit that might be a little harder to get just the seat.
Yeah probaly would help to know what it is going into…a P-51D mustang…the hasegawa kit…I have been looking at the stock seat that came w/ the kit, trying to figure out a way to mod that one…
Ashton
I have not seen anyone sell just the seat for the Mustang. It is probally the right thing you are doing to try and make the best of it with the factory part. I bet you can spruce it up a bit and bring it up to the level of the rest of the interior.
Soulcrusher