Badger TC910: need some feedback help

[keilau]

Hi keilau,

Thanks for the info. That is a nice looking gauge… I like the fact it only goes to 60 which makes it easier to read and set in between increments. Will consider updating in the near future but at point of just getting a brand new compressor I would have hoped the stock one worked. Well maybe I’m jumping the gun here… hard for me to say, maybe there is damage somewhere else I’m not seeing. I can only notice there are no leaks because when the compressor is set to on and left alone for 20-30min the compressor dose not kick in.

Will keep you posted.

Can you elaborate on what you mean by this? “when the compressor is set to on and left alone for 20-30min the compressor dose not kick in.” Yes, if you are not using any air, the motor should not kick in. If so, it is good.

Small oilless airbrush compressor are sensitive to heat. If it gets hot during operation, it may not last too long. A well made compressor will run very quiet and very cool.

You may find this old post on TC-910 interesting.